Conventional supporting method for intelligent electromagnetic flowmeter.

Is an intelligent electromagnetic flowmeter just a measuring flow meter? To achieve the quantitative control needs and other instruments and valves to cooperate with the movement. So let's talk a little bit about some of the conventional methods.

Smart intelligent electromagnetic flowmeter can be used to measure flow, the traffic signal to control device, flow control device, can be set when the instantaneous flow rate reaches much signal to the regulator to shut down action. It can also set the cumulative flow to achieve certain numerical control. The application of intelligent electromagnetic flowmeter in liquid medium measurement is good and accurate, and it is used for a long time. Only the liquid has a certain conductivity which can be measured.

The intelligent electromagnetic flowmeter can be used with any flow integrator, or it can be sent directly to PLC and computer.

Main functions: intelligent electromagnetic flowmeter flow limit setting, flow limit, flow limit alarm, traffic limit alarm, small signal of functions, set range, pipeline atc alarm, fault alarm, output: the pulse signal, the output current signal.

Lower limit setting function: it is mainly used in some special places. When the flow rate is lower than the set value, the operator will close the valve or shut down the pump according to the need.

Flow limit setting function: when the flow limit is set and the flow exceeds the upper limit, we can usually adjust the valve switch properly.

Small signal resection function: mainly used in some places can have some disturbance, we use small signal excision function setting to ignore small interference signal.

The intelligent electromagnetic flowmeter can also carry out batch control, with the batch control function with the built-in batch controller, can cooperate with filling or feeding process, and carry out the fixed value batch control. If you don't need too much cost, we can also use the most stupid way, so long as flowmeter with a cumulative function, make an operator standing in front of flowmeter, each to a given value, just press the button to stop the pump, the operation also pretty reliable.

Note: the intelligent electromagnetic flowmeter used for quantitative control must be installed correctly according to the requirements of the manual, and it is better to communicate with the technical personnel of the manufacturer before installation.